12 results for "Seachem Reef Buffer 250 gram" between $2.00 and $25.00

Check pH and alkalinity before use. Use 5 g (1 level teaspoon) for every 150 L (40 gallons) to raise pH by about 0.1 pH units (this will also raise alkalinity by about 0.5 meq/L). Dissolve in at least one cup of freshwater, then add to the tank. The pH of natural sea water is 8.25–8.30. In a well established reef system pH adjustment may be necessary biweekly to semiweekly. Dosing requirements will vary, but do not exceed the recommended dose without checking your pH and alkalinity (alkalinity should...

Check pH and alkalinity before use. Use 5 g (1 level teaspoon) for every 150 L (40 gallons) to raise pH by about 0.1 pH units (this will also raise alkalinity by about 0.5 meq/L). Dissolve in at least one cup of freshwater, then add to the tank. The pH of natural sea water is 8.25–8.30. In a well established reef system pH adjustment may be necessary biweekly to semiweekly. Dosing requirements will vary, but do not exceed the recommended dose without checking your pH and alkalinity (alkalinity should...

DIRECTIONS: Check pH and alkalinity before use. Use 5Êg (1 level teaspoon) for every 150ÊL (40 gallons*) to raise pH by about 0.1 pH units (this will also raise alkalinity by about 0.5 meq/L). Dissolve in at least one cup of freshwater, then add to the tank. The pH of natural sea water is 8.25Ð8.30. In a well established reef system pH adjustment may be necessary biweekly to semiweekly. Dosing requirements will vary, but do not exceed the recommended dose without checking your pH and alkalinity ...

DIRECTIONS: Check pH and alkalinity before use. Use 5???g (1 level teaspoon) for every 150???L (40 gallons*) to raise pH by about 0.1 pH units (this will also raise alkalinity by about 0.5 meq/L). Dissolve in at least one cup of freshwater, then add to the tank. The pH of natural sea water is 8.25???8.30. In a well established reef system pH adjustment may be necessary biweekly to semiweekly. Dosing requirements will vary, but do not exceed the recommended dose without checking your pH and alkalinity...

Reef buffer is intended primarily for use in a reef system where the maintenance of a ph of 8.3 is often difficult. When used as directed reef buffer will raise the ph of your reef system to 8.3 without fear of accidentally overshooting the ph to a danger. . .

Reef Builder ™ raises carbonate alkalinity without immediately impacting on pH. With long term use there will be a tendency to stabilize at pH 8.3. Carbonates and calcium are essential to all coral growth. If either becomes deficient, coral growth will cease, followed by a rapid decline in coral health. Used as directed, Reef Builder™ will not deplete calcium, magnesium, or strontium which usually tend to precipitate with increasing alkalinity. Reef Builder™ and Reef Buffer™ may be used together...