10 results for "Amana - AMA512721-30 - 12" Non-Ferrous Metal (B000WXKKAU)" between $50.00 and $250.00

Amana 512961 Non-Ferrous Metal Blade -6º Hook - Triple Chip (TC) Grind This blade is specifically for cutting relatively thin-walled aluminum and non-ferrous extrusions and frames. Use a coolant or blade wax and clamp down the workpiece when cutting non-ferrous metals. Specification D - Diameter:12" (300mm) Teeth:96 Grind:TCG Tool No.:512961 B - Kerf:.126" C - Plate:.102" Bore:1" WARNING: NEVER attempt to cut ferrous metals (steel, iron, etc.) with this saw blade.

Thanks to its special carbide formulation and blade geometry, this is the ideal blade for cutting relatively thick-walled aluminum and non-ferrous metal bars such as copper, brass, bronze and lead. It also is good for cutting extrusions and profiles. The negative hook angle (-6°), triple-chip grind and thick plate combine to produce a superior finish. Use a coolant or blade wax and clamp down the workpiece when cutting non-ferrous metals. The blade can also be used to cut other "difficult" materials...

Saw Blade Application: California Triple Chip design of tooth is the perfect choice for the picture frame industry. Bur-free cuts in aluminum and other non ferrous metals. Cuts clean wood and wood products. Works in miter saw, compound miter saw and sliding compound saw. -5° hook.

This style blade is the perfect choice for picture frame and millwork shops. Unlike thinner miter blades which have a tendency to flex and warp, throwing off the miter joint. Our Blades are stiffer and provide clean burr-free cuts in wood, aluminum and non-ferrous metals. Special grind, minimal run-out and tight side clearances all combine to yield perfect “ GAP-FREE ” miters every time!

Amana's German-made saw blades are significantly less expensive than other professional quality blades. Unlike most so-called 'bargain blades', these are all a full 1/8" thick, have precision ground, resharpenable carbide teeth, good tooth geometry and careful machining. What they lack are heavy advertising, fancy packaging and special coatings. If you don't want to spend a gang of money for specialty tooling like laminate and non-ferrous metal blades, or if you just want a couple of first-rate...