17 results for "Amana 571923/4 Rounding Over Bit" between $25.00 and $200.00

Amana 57192 Specifications: Diameter: 2-1/8" Depth of Cut: 1-1/2" Radius: 3/4" Carbide Height: 1" Shank: 1/2" Length: 3"Amana 57192 Features: A unique pilot bearing allows you to produce a true 180degrees bullnose with this corner rounding bit. Unlike a regular square-edge bearing it follows the radiused surface produced on the first pass. Will neither leave a flat spot nor gouge the edge. Use the (optional) regular 1/4" x 5/8" steel bearing for the first pass.

Amana router bits are built of carbon steel alloys that are impregnated with vanadium particles. The vanadium both increases a router bit's internal structural strength while also preventing corrosion, allowing the router bit to withstand extreme stress under heavy load over time without cracking or breaking. Amana Router Bits are laser etched with the Amana brand and the bit's vital specifications so you'll have the RPM range and clamping depth you need to know.

Amana router bits are built of carbon steel alloys that are impregnated with vanadium particles. The vanadium both increases a router bit's internal structural strength while also preventing corrosion, allowing the router bit to withstand extreme stress under heavy load over time without cracking or breaking. Amana Router Bits are laser etched with the Amana brand and the bit's vital specifications so you'll have the RPM range and clamping depth you need to know.

Amana Tool Corp. 57190 - ROUNDING OVER BIT 1/2 RADIUS

The basic edge forming bit, the corner-rounding bit rounds an edge to a given radius. The tool is shouldered to cut a fillet. The cut can be used to ease edges, as a simple profile, or as a part of a complex one. Also known as roundover, rounding over, and quarter-round. If a smaller pilot bearing is used, a second shoulder can be produced, in effect making the bit a beading bit.

These 2-Flute Round Over Groove Router Bits from Amana create a flat-bottom groove between two quarter-round shapes. Short vertical walls extending below the radius lend extra depth to the appearance.

Amana Tool 49706 Carbide Tipped Plunging Round Over 1/2 Radius x 1-3/8 Dia x 1 Inch Cut Height x 1/2 Shank Router Bit

Use with Corner Rounding bits to cut a full 180° bullnose on 1/2", 1", 1-1/2" or 2" thick stock WITHOUT TURNING THE MATERIAL OVER. (Two 30" x 98" x 1/2" laminated sheets = 200lbs.+). Also useful for on-site cutting where a conventional round-over can not be used. Furnished with Ultra-Glide™ non-marring Delrin® sleeved ball bearing. Carbide-Tipped.

Application: Use with corner rounding bits, to cut a full 180° bull-nose on 1/2", 1", 1-1/2" or 2" thick stock without turning the material over. (Two 30"x98"x1/2" laminated sheets = 200 lbs. +). Also useful for 'on-site' cutting where a conventional round-over cannot be used. Furnished with Ultra-Glide™ non-marring Delrin® sleeved ball bearing guide. Replacement 'Ultra-Guide™' bearing #47737 (after 6/95). Replacement steel bearing #47738 (prior to 6/95). Replacement collar #47740. Warning: Maximum...