13 results for "Amana 542213/8" Ogee with Back Cutter Router Bit" between $50.00 and $300.00

Amana 54221 Specifications: A Reveal: 1-3/8" Diameter: 3-3/8" Radius: 7/8" Carbide height: 1-3/16" Shank: 1/2" Length: 3-1/16"Amana 54221 Features: Replacement bearing #47713 (8MMx16MM) and #47763 (8MMx1-1/4"). Back Cutter #55435=1/4" Kerf; 5/16 Radius Cutter. Note: Reveal ( 'A') shown on tools reflects the total length of cut. Therefore you must deduct (usually 3/8") for allowing the panel to recess into the frame.

Cutting Diameter 3-3/8-Inch 1/2-Inch Shank, 1-1/16-Inch Cutting Height, 1-9/16-Inch Upper Radius, 5/16-Inch Lower Radius Carbide Tipped, Industrial Quality Max RPM = 12,000! For use only in a table mounted router., Manufacturer: Amana Tool

An industry leader for over 50 years, the Freud name equals quality, precision and craftsmanship. Freud router bits feature Freud made TiCo Hi-Density Carbide for maximum cutting life. Each bit is individually balanced, giving a cut above the rest. Revolutionary Quadra-Cut design employs four cutting edges vs. two, for a flawless finish that requires no sanding or rework. Two carbide cutters have an up-shear angle to remove most of the stock while the second pair of down-shear cutters makes a final...

1. CMT carbide and carbide tipped router bits and saw blades are designed, engineered and manufactured to uncompromising standards for optimum performance and service life. If, for any reason, you are not satisfied with the performance of your CMT tools, and the tools were used only for their recommended application and in accordance with CMT's recommendations, you may return them to CMT for replacement. Warranty excludes dull, misused, damaged, or re-sharpened tools.

2 Flute - 1/2 Shank Raised Panel with Back Cutter This three-piece set combines the two-piece ogee stile-and-rail cutter set with a cove raised panel bit with a backcutter. Use only in a tablemounted router; the panel-raiser must be run at reduced RPM’s.

Cut your cutting time in half. This new style allows you to make your backside cut at the same time you are milling the front of a raised panel. This heavy duty Whiteside bit is beefy enough (and sharp enough) to make a clean cut through oak, maple or whatever you throw at it. By reducing your number of runs through your router you reduce your chance of mistakes while guaranteeing a standard tongue thickness around your panel.

Amana Tool 55342 Ogee Profile Cutter for 55340 Router Bit