17 results for "Amana 51402 Aluminum Solid Carbide Router Bits - 1/4" Cutting Diameter; 5/8" Cutting Height" between $10.00 and $100.00

Solid Carbide Spiral 'O' Flute, Aluminum Cutting Up-Cut & Down-Cut Router Bits

Amana 51204 Flush Cut Single Flute Pilot Router Bit, Solid Carbide Here's the ideal laminate trimming bit for high-volume production. Solid carbide and integral pilot (no bearing to maintain) extend life of bit, slim configuration reduces vibration. Suitable for routers and trimmers. Specification D - Cutting Diameter:1/4" B - Cutting Length:1/4" Tool No.:51204 d - Shank Diameter:1/4" L - Overall Length:1-7/16" Type of Cut:Flush

THE NEW IMPROVED Spiral-flute bits combine a shearing action in cutting with an augering action in chip clearance. The shearing action yields an especially clean, accurate cut, while the augering action clears chips from the cut. The “up-cut” shears from the bottom up, pulling chips from the bottom up, thus allowing deeper penetration with less stress on the tool. An excellent choice for mortising. The “down-cut” cuts from the surface down, leaving a smooth edge at the surface. Special unique carbide...

Description Amana 51708 Rip and Slotting Router Bit, Single Flute, Solid Carbide Use this bit for cutting sheets of laminate, paneling, and other thin material, as well as plowing narrow slots, dadoes, and grooves. Specification D - Cutting Diameter:1/4" B - Cutting Length:5/16" Tool No.:51708 d - Shank Diameter:1/4" L - Overall Length:1-1/2"

Amana 51702 Veining Router Bit, Single Flute, Solid Carbide Rout fine-line designs in laminate-covered and wooden surfaces with this bit, designed specifically for use in a laminate trimmer. It produces a round-bottomed groove. Specification D - Cutting Diameter:3/16" R - Radius:3/32" Tool No.:51702 d - Shank Diameter:1/4" L - Overall Length:1-1/2"

For high volume, high speed cutting in dense natural woods and abrasive wood composites, use solid carbide bits. Solid carbide dissipates heat more uniformly, extending tool life. Single flute bits cut faster, with better chip clearance. Two-flute bits cut more slowly, but leave a smooth finish.

Fast, strong set up anywhere, on a steel table or Iron fence. Also mounts to Miter Gauges and Fences. Completely universal, accepts all standard hardware. One side accepts all standard T-Bolts and 1/4" Hex Bolts. The other side accepts all standard T-Bolts, 5/16" Hex Bolts & Kreg® clamps. Solid aluminum construction for years of service. Included micro adjust brackets for fine tuning. Measures 36" long x 4" tall.

Designed to cut precise grooves to provide undersized plywood veneered panels with a snug rattle free fit. Adjust the panel groove width (3/16" to 9/32" for 1/4" plywood - 7/16" to 17/32" for 1/2" plywood).Cut frame stock for 5/8" through 1-1/4" in thickness. Each set includes 2 pcs. (1 for stile cuts & 1 for rail cuts and shims).Carbide- tipped for longer cutting tool life.

Solid carbide compression spiral bits are designed for CNC applications requiring high feed rates and a clean finish. Particularly suitable for double-sided melamine or laminated material. Choose either single flute for the highest possible feed rate or double flute for the best finish. Special unique carbide for longer lifetime in abrasive material.