70 results for "Addonics-RAID 5/JBOD ESATA CARDBUS-Controller Interfaces" between $25.00 and $400.00

Add two eSATA ports to Notebook PC via one CardBus slot. Port Multiplier compatible. Maximum 150 MB/sec. data throughput. Support hard drive of capacity 137 GB or higher in one big partition. Built in firmware RAID support for RAID 0, 1, 5, 10 and JBOD (JBOD can combine multiple hard drives into one large drive or set to run as individual drive with no RAID). Work with any Addonics Pocket Series and Mobile Series devices using Addonics optional External Serial ATA interface cable. eSATA connector...

General Information Designed to the latest 3Gbits/sec ASIC from Silicon Image and eSATA connector, this 4-port controller incorporates many advanced features that are only found in some expensive RAID controllers. Technical Information Host Interface: PCI Express x8 Data Transfer Rate: Up to 300MBps per Port RAID Levels: 0 RAID Levels: 1 RAID Levels: 1+0 RAID Levels: 5 RAID Levels: JBOD Platform Support: PC Interfaces/Ports Ports: 4 x 7-pin eSATA - External SATA Physical Characteristics...

Initially SATA was designed as an internal or inside-the-box interface technology, bringing improved performance and new features to internal PC or consumer storage. Creativedesigners quickly realized the innovative interface could reliably be expanded outside the PC, bringing the same performance and features to external storage needs insteadof relying on USB or 1394 interfaces.

Hardware RAID, supporting RAID 0, 1, 10, 3, 5+hot spare, JBOD and CLONE. Over 200MB/s read and 170MB/s write performance. eSATA and USB 3.0 interfaces. Backward compatible with USB 2.0. Bundled with SATA 6.0Gbps PCIe 2.0 x1 controller card. Supports PCIe 2.0 with over 200MB/s performance. Backward compatible with PCIe 1.0 slot.

Hardware RAID, supporting RAID 0, 1, 10, 3, 5, JBOD, Clone and hot spare disk. Over 200MB/s read and 170MB/s write performance. eSATA and USB 3.0 interface. Backward compatible with USB 2.0. Bundled SATA 6.0Gbps PCIe 2.0 x1 controller card, support PCIe 2.0 with over 200MB/s performance. Backward compatible with PCIe 1.0 slot is supported. True hardware RAID design within the enclosure, no driver and no additional RAID controller needed.

RAID 0 (Striping), RAID 1 (Mirroring), RAID 0+1 (mirrored-stripping), RAID 5 (Distributed Parity RAID) and JBOD (Just Bunch of Disks) manage multiple disk drives to enhance I/O performance and provide redundancy in order to withstand the failure of any individual member, without the loss of data.

The new Addonics eSATA II RAID5/JBOD controller ensures maximum data throughput of 3 Gbits/sec per port when installed into the PCI-X bus. The controller features the latest eSATA connector to provide EMI protection, improved durability, and a complete cabling solution to ensure SATA signal integrity in external applications up to seven feet. Throughput of up to 200 Mbytes/sec sustained data transfer can be achieved using standard 7,000 RPM SATA hard drives by setting up four drives in a RAID 0 configuration...

Fully compliant with Serial ATA 1.0a and Serial ATA II Extensions to Serial ATA 1.0a Specifications revision 1.1. Support SATA II transfer rate of 3G/sec (300 MB/ sec). Maximum transfer rate per port (150 MB/sec)*. Compliant with SATA 1.0 specification. Supports SATA II First-party DMA commands for Native Command Queuing (NCQ). Supports Serial ATA II Port Multiplier 1.0 Specifications revision 1.1. Plesiochronous, Single PLL architecture, 1 PLL for 4 ports. 48-bit LBA support. Four independent...

I/O Ports: (2) 40-pin IDE connector. Interface: 32 bit, 33MHz fully compliant PCI host interface. 48-bits LBA to Support HDD larger than 137GB. Two independent Ultra ATA-133 channels. Installs into both standard height or low profile systems. On board firmware support for RAID 0, RAID 1, RAID 10, JBOD. Supports full speed burst transfers on the ATA bus. Supports software-controlled ATA bus tri-state. Features one 256-byte FIFO (32-bit x 64 deep) per IDE channel for host reads and writes....

Highlights: ?2x eSATA 3Gb/s ports for support of upto 2 eSATA disk and tape drives ?PCI-Express x1 host interface ?RAID 0, 1, and JBOD ?Native Command Queuing ?Greater than 2TB support ?Low-profile form factor ?eSATA tape support ?RoHS compliant ?eSATA Benefits Include: ?5X faster than USB 2.0 or 1394 ?More secure connections ?Better durability ?Increased EMI protection for cables upto 2 meters ?RAID Levels: RAID 0, 1, and JBOD (individual drive) ?Number of Devices:...

Hardware RAID, supporting RAID 00, 30, 50, JBOD. Over 200MB/s read and 170MB/s write performance. eSATA and USB 3.0 interface. Backwards compatible with USB 2.0. Bundled SATA 6.0Gbps PCIe 2.0 x1 controller card, supports PCIe 2.0 with over 200MB/s performance. Backwards compatible with PCIe 1.0 slot is supported. True hardware RAID design within the enclosure, no driver or additional RAID controller needed. Supports SATA hard drives. 8 x Hot Swappable Hard Drive Trays. Over 2TB per volume...

4 Serial ATA interface ports. Fully compliant with Serial ATA 1.0 specification. Independent 256-byte FIFOs (32 bit*64 deep) per Serial ATA channel for host reads and writes. Compliant with 32-bit, 33/66 MHz PCI 2.2 host interface. Integrated PCI DMA engines. Build-in RAID 0, RAID 1, RAID 1+0, RAID 1+S, RAID 5, JBOD support. RAID 0+1 (Mirrored-Stripping) combine both Striping and Mirroring technologies to provide both the performance enhancements that come from Striping and the data availability...

the New Addonics Esata Ii Raid5/jbod Controller Ensures maximum Data Throughput Of 3 Gbits/sec Per Port When Installed Into The Pci-x bus. The Controller Features The Latest Esata Connector To Provide Emi protection, Improved Durability, And A Complete Cabling Solution To Ensure Sata signal Integrity In External Applications Up To Seven Feet. throughput Of Up To 200 Mbytes/sec Sustained Data Transfer Can Be Achieved using Standard 7,000 Rpm Sata Hard Drives By Setting Up Four Drives...

Support all brand of 3.5 SATA I / II / III hard disk drive up to 3TB per drive. Hardware Raid controller built-in on board. Transfer rate up to 5.0Gbps via USB 3.0. Transfer rate up to 3.0Gbps via eSATA. Power Sync: Power off in synchronization with PC. Forced Convection Process. Smart Fan function Thermal-Sensor built-in Auto & Manual mode 3 level of speed. One button interface selection: Switch USB 3.0 or eSATA interface by pressing one button. Raid Mode Support Raid 0 (Spanning) JBOD Raid...

The Series 6 family of high-performance Adaptec Unified Serial (SATA/SAS) RAID controllers offers maximum performance, scalability and reliability. With the enhanced bandwidth of its 6 Gb/s SAS2.0 interfaces and the PCIe Gen2 host connection it offers up to 60% higher sustained sequential throughput than previous generation controllers. Based on PMC-Sierra s market-leading, multi-core SRC 8x6G RAID-on-Chip (RoC) the Adaptec RAID 6805 can deliver up to 2 GB/s sustained data transfer rate to the host...

The Series 6 family of high-performance Adaptec Unified Serial (SATA/SAS) RAID controllers offers maximum performance, scalability and flexibility. With the enhanced bandwidth of its 6 Gb/s SAS2.0 interfaces and the PCIe Gen2 host connection it offers up to 60% higher sustained sequential throughput than previous generation controllers. Based on PMC-Sierra s market-leading, multi-core SRC 8x6G RAID-on-Chip (RoC) the Adaptec RAID 6405 can deliver up to 2 GB/s sustained data transfer rate to the host...