15 results for "13 inch chainsaw bar" between $10.00 and $1,500.00

It takes less power from the saw to make the same length of cut with a narrow-kerf bar chain cutting system than with a standard bar and chain. Micro-Lite is the bar for occasional woodcutters who want the advantages of a narrow-kerf cutting system. Oregon Micro-Lite chainsaw bars are designed to be used in conjuncture with narrow kerf saw chain. The bars are slightly thinner than standard chainsaw bars to match the chain kerf. It takes less power from the saw to make the same length of cut with...

Carlton Timber Champ bars are designed for semi-professional and professional chainsaw operators who want performance and value. These bars are made with heat treated alloy steel components for long life. Rails are induction hardened rails and stress relieved for integral strength. Sprocketnose is held in place by 4 sturdy rivets. Made in Taiwan.

Sprocketnose bars for professional use. These bars are commonly found on small to medium sized commercial saws. Made from three pieces of laminated super tough chorme-moly steel. These bars are lighter and less expensive than their solid counterparts. Sprocketnose tip is is held in place with 4 rivets and is easily replaceable with a kit. Please note drive link count in bar description to make sure your chain will fit. Made in the U.S.A. and Canada.

It takes less power from the saw to make the same length of cut with a narrow-kerf bar chain cutting system than with a standard bar and chain. Micro-Lite is the bar for occasional woodcutters who want the advantages of a narrow-kerf cutting system. Oregon Micro-Lite chainsaw bars are designed to be used in conjuncture with narrow kerf saw chain. The bars are slightly thinner than standard chainsaw bars to match the chain kerf. It takes less power from the saw to make the same length of cut with...

Chain Saw Bar, 13 In, For Use With 5nwj8

* Cutting Capacity: 13" (330 mm). * System: Super Spool selector control for use on Open- and Closed-Center hydraulic systems. * Extension Type: Fiberglass – tested to 100 KvA for 5 minutes. * Overall Length: 75" (1,905 mm). * Width: 4" (102 mm). * Flow Range: 5 - 8 gpm (19 - 30 lpm). * Operating Pressure: 1,000 - 2,000 psi (69 - 140 bar). * Pressure Port Thread: 9/16 - 18 SAE O-Ring. * Return Port Thread: 3/4 - 16 SAE O-Ring. * Chain Size: .325" (8.3 mm) pitch (F030030). * Bar Gauge: ...

To reduce chain stretch and tensioning downtime, use 20 PSI (1.4 bar) or greater water pressure. Oil the chain at the end of the day to prevent rust but be careful not to over tension in this condition. When pulling the chain around the bar by hand, be careful not to touch the bar with thumb or forefinger. The bar rails can be very sharp. Grab only the diamond segments to pull the chain. Always pull the chain away from the Wallwalker. The point of the Wallwalker can also be very sharp. Always...

20 In. Gas Chainsaw with Case - 952802146. 46cc 2-cycle DuraLife chrome gas chainsaw. 20 in. steel guide bar. Automatic chain oiler. SuperClean air filter system extends the life of the air filter. Effortless pull starting system. Patented tool-less chain tightening system. Anti-Vibe handle - reduces operator fatigue. Includes case. Fully assembled. Made in the USA. Weight: Approximately 21.11 pounds. Shipping Dimensions: Approximately 21 x 15 x 13 inches.