86 results for "12V DC Wall Mount Transformer" between $10.00 and $600.00

This remote electronic transformer converts standard 120 volt line voltage to 12 volts, providing the necessary voltage for powering Two-Circuit MonoRail low-voltage lighting system. Each transformer includes fast-acting short circuit and overload protection that will safely turn the system off should a short occur. Once the short has been removed the unit can be reset by simply flipping the wall switch off and back on. Transformer power lamps totaling up to 600 watts. Mounted on a plate with junction...

This remote magnetic transformer converts standard 120 volt line voltage to 12 volts, providing the necessary voltage for powering MonoRail, Kable Lite, TwinRail, Wall MonoRail, or FreeJack low-voltage lighting systems. Can be used to power lamps totaling up to 600 watts. Equipped with fast-acting secondary circuit-breaker that will safely turn off the system, should a short occur. Once the short is removed, the breaker can be reset.

This remote magnetic transformer converts standard 120 volt line voltage to 12 volts, providing the necessary voltage for powering MonoRail, Kable Lite, TwinRail, Wall MonoRail, or FreeJack low-voltage lighting systems. Equipped with fast-acting secondary circuit-breaker that will safely turn off the system, should a short occur. Once the short is removed, the breaker can be reset. 150W.

The Westwood 901 and 901-2 are ultra-compact MR11 line voltage fixtures with integral 12-volt step-down transformers. Each mounts directly over any standard 4-inch wall-mounted J-box. Various lenses, louvers, and color or dichroic filters can be combined - up to three at once - to create multiple lighting effects. 200° tilt, 360° rotationStandard integral 12V step-down transformerPrecision machined aluminum housing, hood, and stem with spun canopyStainless steel hardwareRemovable hood for easy relamping...

150W 12V Output, 120V Input Enclosed Electronic Transformer - 6-1/4"L x 3"W x 1-5/8"H - Use enclosed transformers for all initial installations to ensure safe and primary side connections in a wiring compartment - Dimming with electronic low voltage dimmers is recommended

Approved for remote applications. Reset circuit breakers protect secondary (low voltage) output by limiting each Decolume run to 25A maximum load in compliance with NEC requirements for low voltage wiring. Transformer may be remote mounted as far as 40 feet away from Decolume fixture. High saturation magnetic core ensures quiet operation and allows use of inexpensive standard incandescent dimmers.

Electronic internal reset-able protection. Patent pending auto heat regulation that also automatically acts as overload protection. Thermal auto-reset 125ºC switch. Aluminum casing. Dimmable with standard dimmer. Weight: 3 ounces. Lead wire length: 6". Max ambient temp. 50ºC. Output wire Blue: 14AWG 200ºC. Input wire White/Black: 18AWG 150ºC. Minimum load w/o dimmer 10W. Minimum load with dimmer 20W.

Power Supply, Wall Transformer, Input 120VAC, Output Regulated 12VDC 400ma Via 2.1x5.5mm Locking Coaxial Plug (Center[+])

The receiver plugs into a standard wall outlet and is powered by a 12Volt transformer. Other features on the receiver is a 5 minute exit delay which gives you time to delay sensor activation so it won't detect you leaving the house. The receiver also has four "c" relay outputs and one 12Volt DC output allowing you to tie in additional products to the receiver.

Mount Electromagnetic Door Holder 12V 24V 120V Ac/DcThe Sentronic SEM 7800 Series are heavy duty, electrically controlled door holding magnets. Magnets are fail safe and hold until the current is interrupted. A manual door closer is used to control and close the door. A choice of floor, recessed wall, or surface mounted wall magnets are available. All SEM series magnets are UL listed for smoke barrier or labeled fire doors. Tested and certified under ANSI Standard A156.15.Tri-voltage design with...

Dimensions: 6.25 H x 4 W x 2.75 D. Aluminum body. Bronze finish. 35 Watt MR16 120V or 12V fixture option. Transformer included (12V only). Damp-location listed. Wall mount. ADA Compliant. Lamp included.

**NEW ITEM** 12vdc, rated for up to 16ft of wire - with Slide switch - Modes: Constant on and Flash. Comes with cig jack for automotive use or you can cut off jack and use your own external 12v source. Dimensions: 2-1/4x3/4x1

Harness your vehicle's battery to efficiently power office equipment on the road or power tools at a work site. Continuously supplies up to 1250 watts of 120V AC power to 2 AC outlets from any 12V battery or automotive DC source. Frequency control locks AC output at 60Hz for operating stability of motor loads. Includes a set of high current DC input terminals for simple, permanent installation. Highly reliable large transformer design specializes in powering motors and other inductive loads with...

Input: 120VAC@60Hz. Output voltage: 12VAC. Output current: 1000mA. Output Plug: 2.5 mm x 5.5 mm, female. Cord length: 6'. UL, CSA approved. Color: black. Dimensions: 3 1/4"H x 2 3/8 "W x 2.00"D.

Mount Electromagnetic Door Holder 12V 24V 120V Ac/DcThe Sentronic SEM 7800 Series are heavy duty, electrically controlled door holding magnets. Magnets are fail safe and hold until the current is interrupted. A manual door closer is used to control and close the door. A choice of floor, recessed wall, or surface mounted wall magnets are available. All SEM series magnets are UL listed for smoke barrier or labeled fire doors. Tested and certified under ANSI Standard A156.15.Tri-voltage design with...

The EPL-PM-1X150-120X12I-100 Pedestal Mounted Explosion Proof Light provides 1,500 square feet of work area coverage with 1,520 lumens of light output. The 150 watt halogen lamp on this unit produces illumination in a wide flood pattern and provides an economical alternative to higher priced light sources. This portable unit is waterproof and tested to 500 hours of salt spray exposure in accordance with MIL-F-8115C Military Specifications. An included inline transformer steps down standard 120VAC...