27 results for "1/4 x 1-1/2 Expansion Pin Anchor" between $0.00 and $100.00

The Split Drive anchor is a one piece anchor, with a split-type expansion mechanism on the working end. As the anchor is driven into the hole, the expansion mechanism compresses and exerts force against the walls of the hole. Can be installed in concrete, grout-filled block and stone. Available in mushroom, countersunk and duplex-head styles. The duplex head Split Drive is designed for temporary fastening applications and can be removed using a claw hammer.

Nylon Shell Acts as an Insulator in Electrical Applications. A Light Duty Anchor.

*Easy to install — just hammer the center pin and it’s set. Anchor tensions itself automatically, so no wrench is needed. *Visually inspectable — anchor is set when center pin is flush with top of hole. *Depth of hole not critical — no depth gauge required. *No templates required — the actual diameter of the anchor is the same as its nominal diameter. *Yellow dichromate finish for superior corrosion resistance.

1/4 x 2 Zinc w/Steel Pin Mushroom Head Pin Drive Anchor

1/4 x 1-1/2 Zinc w/Steel Pin Mushroom Head Pin Drive Anchor

1/4 x 2 1/2 Cotter Pin Zinc - These cotter pins consist of a double bodied pin formed from half-round wire, a loop at one end of which provides a head. The finished part has one end of the wire extending beyond the other end, with a chiseled point. Cotter pins are used to anchor various assemblies by insertion into a drilled hole of a shaft or pin and spreading the points to hold the assembly in position. When used with castle or slotted nuts, it becomes a safety locking device. Manufactured from...

1/4 x 1-1/2 Zinc w/Stainless Steel Pin Mushroom Head Pin Drive Anchor

*Easy to install — just hammer the center pin and it’s set. Anchor tensions itself automatically, so no wrench is needed. *Visually inspectable — anchor is set when center pin is flush with top of hole. *Depth of hole not critical — no depth gauge required. *No templates required — the actual diameter of the anchor is the same as its nominal diameter. *Yellow dichromate finish for superior corrosion resistance.

Nylon Shell Acts as an Insulator in Electrical Applications. A Light Duty Anchor.

1/4-20 x 1 3/4 Simpson Wedge Anchor 304 SS (100) - WEDGE-ALL® wedge anchors are a non-bottom bearing, wedge style expansion anchor for use in solid concrete or grout-filled masonry. A one-piece clip ensures uniform holding capacity that increases as tension is applied. The threaded stud version is available in eight diameters and multiple lengths. A single size tie-wire version is available for wire supported fixtures. Threaded studs are set by tightening the nut.

1 to 9$0.36 Per EA. 10 to 24$0.30 Per EA. 25 to 49$0.24 Per EA. 50 to 99$0.22 Per EA. 100 to +$0.19 Per EA.