9
flame guard paint additive
$0
$28
/flame+guard+paint+additive?
|
Designed for flameproofing props & scenery. Add Flamex to any water-based paint & turn it into a flame retardant paint.
|
|
|
PPG DX54-QT SIZE: QUART ROAD GUARD PPG Industries Paint Company PPG PAINT ADDITIVES
|
|
|
RoscoFlamex offers a full range of flame-retardants for scenery. The clear liquids are best applied by immersion, brushing or spraying. Flamex C26 Natural fibers is for use on muslin, muslin-covered flats, etc. Flamex W40Raw is for use on wood that is not to be repainted. Flamex S33 Synthetics is for synthetic/cotton blends. Flamex P50 can be mixed with scenic paints or sealers, Foamcoat or Polystyrene foams. Apply Flamex C26, W40 and S33 before painting; mix C26 with the priming or base coat or...
|
|
|
Inhibits mold and mildew. Indoor/outdoor use. For latex and solvent paint and water based adhesives.
|
|
|
Over use too much the penis purchase xanax to swell the the penis enlargement programs, purchase xanax Drugs purchase xanax Exercises Recommended by Herbal Virility purchase xanax program purchase xanax
|
|
|
This lot contains three Imperial Hellhound Flame Tanks. All models are supplied unpainted and unassembled.
|
|
|
Rosco Laboratories 07950-0012 Roscoflamex P50 paint additive. Makes flameproofing your props and scenery easier than ever. This pre-measured container of clear liquid can be added directly to one fluid gallon of water-based Rosco paint turning that paint into a flame retardant coating. Perfect for backpainting hard scenery, and can be added to Rosco Clear Acrylic Glaze to create a fire retardant clear sealer. Contains no pigments and will not alter the color of the paint.12 oz. Jar. TMGR# 07950-0012
|
|
|
Vintage cone-top metal can, partially full, or DuPont Gas Guard. Can is in very good condition with no damage or holes. Original paint is nice with only light wear. Exposed tin shows some very faint surface rust. 12 ounce size.
|
|
|
|
Just one application of Flame Stop III™ will provide a Class A fire rating. The mixture is 16 ounces of Flame Stop III ™ (as it comes in the container) per 1 gallon of paint. Mix thoroughly and apply according to the instructions of the paint manufacturer. In most cases, the mixture will become thicker than desired and will require approximately 1-2 pint of water to be added, therefore, it can be said that Flame Stop III is also useful as a paint extender. If Flame Stop III has been stored in a...
|
|
|
(US)
