5
USB to UART Bridge - FT232RL
$0
$21
/USB+to+UART+Bridge+-+FT232RL?
|
USB to UART Bridge - FT232RL
Implements full v2.0 USB protocol. Needs no external crystal. Requires only a pull-up resistor and two decoupling caps. Internal EEPROM for device ID and Product Description strings. Royalty-Free Driver support for Windows, Linux, and Mac OSX.
|
$3
See 2 Stores
See All Stores
|
|
This 24-Pin DIP USB-Serial UART (TTL) evaluation/development module is based on the FT232R IC from FTDI.
|
|
|
|
Product Info USB to UART Bridge - CP2102 sku: COM-00310 Description: Silicon Laboratories USB to UART IC. The latest units from Signal: the CP2102 is a drop-in pin replacement of the CP2101. Vastly superior to the FTDI chip in many ways: Implements full v2.0 USB protocol Needs no external crystal Requires only a pull-up resistor and two decoupling caps Internal EEPROM for device ID and Product Description strings Also available is the CP2102 Breakout Board! Documents: Silicon Labs website CP2...
|
|
|
* USB 2.0 compliant Full Speed 12Mbps maximum speed; Suspend supported. *. * UART supports 5-8 bit data, 1-2 Stop bits, odd/even and no parity. * Integrated EEPROM for Vendor ID, product ID, serial number, release number. * On-chip 3.3V regulator available; power on reset circuit. * Virtual COM port drivers allow operation with existing COM port PC applications. * Supports Windows, MAC (OSX-9 and above) and Linux (2.4 kernel and above). * Self powered or USB powered; -40 to +85 deg C temp...
|
|
|
|
Product Info USB to UART Bridge with GPIOs - CP2103 sku: COM-00309 Description: Silicon Laboratories USB to UART IC. The latest units from Signal: the CP2103 is a extended version of the CP2102 and CP2101. All the functionality with the addition of four general purpose I/O pins. That's right! You can drive four GPIO pins independantly via USB! Implements full v2.0 USB protocol Needs no external crystal Requires only a pull-up resistor and two decoupling caps Internal EEPROM for device ID and Product...
|
|
|
(US)
